Page 9

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.

REQUIRED FOR A SUCCESSFUL REFILL:

Toner (Uni-Kit Formula 1A)

1 funnel cap

1 hole plug

Toner Hole Making Tool

General Refilling Procedures:

Rest the Hole Making Tool on its stand and plug into an outlet. Wait 3 full minutes be-

fore using. Remove the label using a flathead screwdriver. Position the copper bit on the

cartridge in the spot indicated by the photograph and push gently until it melts a hole

in the cartridge. Remove the tool, place it back on its stand and unplug it. If the small

piece of plastic has fallen into the cartridge, it must be removed, as this can damage

your cartridge or cause print defects. If the piece remains in the tool, wait for the tool

to cool down and pry it out.

Before opening the bottle of toner, turn it upside down and tap it on a table to loosen the

toner and allow it to flow freely. Remove the cap and pull the seal off the bottle. Attach

the funnel cap making to sure it is on tightly. Tilt the funnel cap toward the filling hole

and insert it into the hole. If the toner stops flowing before the cartridge is full, simply

remove the toner, close the cap, turn the bottle upside down and tap it on a table. Once

the cartridge is full seal the hole with the plug.

Do not press down on the plug since the cartridge is resting on a table this can actually

damage the photo-optic drum. Instead hold one end of the cartridge up off the table

and twist the plug until it fully sealed. Now gently shake the cartridge side to side to

distribute the toner.

NOTE: If after the cartridge is refilled and it starts to print gray smudges or smears

along the margin, the waste hopper could be full. Please refer to the supplemental in-

structions (page 2) for emptying the waste hopper.

HP C4096A

Xerox 6R928