Page 69

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.

QMS 2300 SENSOR RESET INSTRUCTIONS

COLOR TONER INSTRUCTIONS

1. Remove the three screws with

a screwdriver as shown above.

2. Now locate the fourth screw

(shown above) and remove it.

This will allow you to remove

the endcap. Caution: When

removing the end cap, be

careful not to damage the

copperplate on the cartridge

body.

3. The bottom portion of the sensor has

toothed gears. It is important that you

position the sensor so that the teeth

of the sensor align with the bottom gear

teeth. The above picture shows what it

should look like if done properly.

NOTE: It is important that the teeth mesh

if you hear a grinding noise after resetting

the cartridge and placing it in the printer

then the teeth have not meshed. You need

to open the cartridge and reset the

sensor.

4. Reattach the endcap to the cartridge

with the four screws you removed in

steps 1 and 2. Check that thecopperplate

fits the cartridge properly. Your cartridge

should now be successfully reset