Page 67

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.

COLOR TONER INSTRUCTIONS

RESET PROCEDURE FOR QMS MAGICOLOR 2400 SERIES PRINTERS

The following reset procedure will enable the printer to continue

printing even though the toner level will say "empty".

Magicolor 2400 Series

STEP 1

You need to find the STATUS DISPLAY icon for your QMS 2400 printer.

To locate this icon, go to START PROGRAMS KONICA MINOLTA

2400 UTILITIES and then select "STATUS".

STEP 2

In the menu bar on top, select "PRINTER" and then select "MODE SET-

TING".

STEP 3

Uncheck the "AUTO TONER REPLACE" and then save or click OK if

prompted

STEP 4

Now turn your printer off, and then turn it back on a few seconds later.

That's it!

Magicolor 2430 Series

STEP 1

On your Magicolor 2430 series printer, make sure the panel display says

"READY". Then press the MENU/SELECT button.

STEP 2

By scrolling with the right arrow button, continue until you stop at selection

"ENGINE". Now press the MENU/SELECT button again.

STEP 3

Scroll again with the right arrow button until you get to "TONER EMPTY".

Press the MENU/SELECT button again.

STEP 4

Press the right arrow button until you get to "TONER IS EMPTY OR OUT"

STEP 5

Press MENU/SELECT button once more, and then press the UP arrow until

you see "READY".

That's it!

INSTRUCTIONS ON HOW TO REPLACE THE CHIPS

Replacement chips are available for those customers who want to restore the

"toner level monitoring" features that the chips have. If you have bought the

replacement chip, please follow these simple chip replacement instructions:

1) Remove the old chip by first removing the screw in the top left hand corner

of the diagram below

2) If your cartridge has an original chip with TWO holes in it (same as the photo

below) and if the chip you have bought only has ONE hole, then you need to

follow step (3). If your cartridge does not look like the photo below, then move

on to step (4)

3) --- you can skip this step if your cartridge does not look like the one in the

photo below --- Using a flat utility knife or blade, cut the plastic protrusion that

is behind the chip on the top right corner. This plastic protrusion sticks through

the original QMS 2400 chip but has no purpose. If the replacement chip you

purchased does not have a hole for this protrusion to fit into, the protrusion will

push on the chip unless you shave away at the protrusion by 1-2 mm. Then the

new replacement chip can sit snuggly over the protrusion and not stick out.

4) Replace the new chip by replacing the screw and the new chip in the same

orientation

Photo of a chip with TWO holes and a protrusion jutting through the right hole.

If the new chip you have only has ONE hole on the left, follow step (3) above.