Page 65

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.

Okidata C5100 / Okidata C5150 / C5200 / C5300 / C5400 and Okidata C 7100, Okidata C 7200, Okidata C 7300 /

Okidata C 7500

COLOR TONER INSTRUCTIONS

ALWAYS refill in an area where you can tolerate a spill. Use a area such as a workbench when refilling.

1. Turn the cartridge upside down, so that you are facing the BOTTOM of the cartridge.

2. Locate the plastic handle plastic TAB on the side of the cartridge. They are sometimes blue

in color. The tab is about 1cm x 1cm in size. Depress the TAB. This will unlock the handle.

3. Now you can turn the HANDLE until it exposes a slit opening. Inside this opening is the

chamber that holds the toner.

4. Connect the toner pouring nozzle to the toner bottle, and using the funnel provided you can

now start pouring toner into the toner cartridge. After you have poured all the toner, you

need to close the cartridge by turning the handle in the opposite direction to when you

opened it. You need to make sure that you COMPLETELY close the slit-hole opening

so that no toner can fall out. You need a tight seal to prevent spillage.

Okidata C5100 / Okidata C5150 / C5200 / C5300 / C5400 and Okidata C 7100, Okidata C 7200, Okidata C 7300 / Okidata C 7500

RESET INSTRUCTIONS

The OKIDATA C5100 cartridges have sensors to detect how much toner is left in the cartridge. Some-

times, this sensor will prevent the refilled cartridge from printing. You can quickly and easily "reset"

your cartridge so that the printer recognizes it as a brand new cartridge and allows you to print. First,

it is important to note which cartridge you have - is it a "starter cartridge" (the type that come with a

new OKI C5100 printer), or is it a "replacement cartridge" (did you buy the cartridge separate to the

printer). To identify which cartridge you have, see the picture below

2.If you have the starter cartridge you will need to cut a 1.5" X 11" strip of paper. You will use this piece of

paper to fool the printer and avoid the "cartridge is empty" message. You have 1 sensor for each color, place

this piece of paper between the sensors and the printer as shown in picture above. When you insert the strip of

paper the printer will think that you are using the replacement cartridge from the store (not the starter

cartridge).

Replacement

Cartridge

Starter

Cartridge

1. Look at your cartridge on the side with the blue handle. Determine wich cartridge you have by the tab on

the blue handle. If you have a WHITE tab (show on left) then you just need to wipe this sensor down with a

clean paper towel. This sensor needs to be ABSOLUTELY CLEAN in order for the printer to recognize the

cartridge. You do not need to use the paper reset method. If you have a SILVER tab (shown on right) then you

will need to use the reset method shown below.