Page 63

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.

HP 8500

COLOR TONER INSTRUCTIONS

ALWAYS refill in an area where you can tolerate a spill, like a workbench or outside.

1. Choose a safe surface, such as a work

bench, and place hole making tool to rest

on its stand.

2. Plug the tool into a standard wall power

outlet and wait for the tool to heat up (be

extremely careful, the tool gets VERY

HOT very quickly and can burn you.)

1. Using the hole making tool, CARE-

FULLY burn a hole into the cartridge in the

area shown by the arrow. BE VERY CARE-

FUL not to burn yourself - the tool remains

extremely HOT.

NOTE: Marking a hole in the cartridge

leaves you with the burnt out round piece

of plastic. If this falls into the cartridge, you

need to remove it by turning the cartridge

upside down.

2. Now you can fill the cartridge with

toner by pouring it in, using the toner

bottle and nozzle cap so as to avoid

spillage.

3. After the cartridge is filled, you need

to seal the hole using a plastic plug.

GENERAL COMMENTS:

It is always better to underfill than to overfill a cartridge. You can always add more toner later.

Uni-Kit toner is researched and tested to produce excellent results - your first refill should be nearly 100% same quality as

the original cartridge. It is recommended that you refill the same cartridge no more than 2-3 times, because with each print cycle

the cartridge will wear and tear and quality will slowly diminish.