Page 62

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.

HP 3500 / 4500 / 4600 / 5500

COLOR TONER INSTRUCTIONS

1. Choose a safe surface, such as a work bench, and place the hole making tool to rest on its stand.

2. Plug the tool into a standard wall power outlet and wait for the tool to heat up. Be extremely care

ful, the tool gets VERY HOT very quickly and can burn you

3. After about 3-4 minutes, the tool is ready for use.

ALWAYS refill in an area where you can tolerate a spill, like a workbench or outside.

1. Using the hole making tool, CAREFULLY burn a hole into the cartridge in the area shown by the

red circle BE VERY CAUTIOUS not to burn your self as the tool remains very HOT (see hole

position in HP 3500, 4500, 4600).

NOTE: Making a hole in the cartridge leaves you with the burnt out round piece of plastic. If this falls

in to the cartridge, you need to remove it by turning the cartridge upside down.

2. EMPTY OUT OLD TONER COMPLETELY.

3. Now you can fill the cartridge with toner by pouring it in, using the toner bottle and nozzle cap so as

to avoid spillage.

4. After the cartridge is filled, you need to seal the hole using a plastic plug for the 4500 or duct tape

for the 3500 and 4600, making sure that you have a tight seal.

5. Make sure that the transparent sensor (shown by the blue circle) is completely clean. If it is not, the

printer may not recognize the cartridge.

HP 3500

HP 4500

HP 4600

GENERAL COMMENTS:

The HP 4600 cartridges have "chips" that recognize the levels in the cartridge. If your cartridge does not

print after you have

refilled it, then these chips need to be overid or replaced. We offer 2 procedure to override the chip ink

level. If both dont work, replacement chips can be bought on request.

OVERRIDE PROCEDURE 1: You just switch off and on the machine. Do it when you take out the car-

tridge, and after inserting it again.

The chip does not work with physical contact with the drum, but with a radio frequency. In some cases,

due to this, you will have to switch off and on more than once, this is the only thing that needs to be done

for the machine to recognize the cartridge.

OVERRIDE PROCEDURE 2:

Click on "Menu"

Click on "Diagnostics"

Click on "Disable Diagnostics"

HP 3500 / 4500 / 4600 / 5500 CHIP REPLACEMENT

INSTRUCTIONS

Replace the chip AFTER you

have refilled the cartridge

1. Using a soft cloth, wipe the

area under the chip

clean.

2 Glue / Stick your Replacement

chip in the area

indicated.