Page 61

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.

HP 2600 Color Laserjet (Black, Cyan, Yellow or Magenta)

Make a 2nd hole in the cartridge at the location shown in this diagram. Make sure you remove

the round plastic piece that you burn out. IMPORTANT: Just like with the waste hopper, you

need to EMPTY OUT any remaining original toner from the cartridge. Our toner may not

work as well if it is mixed with the original toner. If there is slight mixing that is OK, just as

long as most of the original toner is gone.

Attach the pouring spout to the toner bottle and fill the cartridge. Seal the filling hole again

with electrical tape. IMPORTANT: Do NOT try sealing the hole with a plug as there is a blade

on the inside of the cartridge that rotates and needs to be able to rotate almost flush with the

cartridge shell, so nothing should protrude into the cartridge.

The first step in refilling your color laserjet HP 2600 cartridges is to EMPTY THE WASTE

HOPPER. This is an essential step because waste toner has accumulated in the hopper (which

is like a waste collection space). You can empty the waste hopper by using the hole making

tool to make a hole at the location shown in the diagram. The tool needs to be plugged in to

an electrical outlet, wait 1-3 minutes for the tool to heat up (be careful - it gets HOT!) and then

gently push the tip of the tool against the cartridge in the location shown until it makes a nice

round hole. You need to remove the round plastic piece that is burnt out by the tool. Now

slowly turn the cartridge upside down over a trash collection bag so that the waste toner can

empty out.

When empty, you can seal this hole using electrical tape.

The chip needs to be replaced. This is a lockout chip, which means that unless you replace

the chip the printer will not recognize the refilled cartridge (it will remember it as empty and

prevent you from printing). In order to remove the original chip, you need to make 2 small

cuts in the plastic at the 2 points on top of the chip that (see diagram). This will allow the chip

to be pushed up and out by using a thin flat object such as a flat screwdriver.

Replace the old chip with a new replacement chip, and add a touch of glue to the top tips of

the chip so that it sits firmly in place against the cartridge.

COLOR TONER INSTRUCTIONS