© All rights reserved, Easy Group, LLC. Version 2.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
41
Sharp ZT20TD1
REQUIRED FOR A SUCCESSFUL REFILL:
Toner (Uni-Kit Formula 5A)
1 funnel cap
1 hole plug
Toner Hole Making Tool
General Refilling Procedures:
1. First you need to remove the END CAP of this cartridge by removing the screws
from the side.
2. Slowly and gently, pull the END CAP out and to the right until you notice that the
"locking tab" has been released (this will make it easier for you to completely remove
the END CAP).
3. Underneath the END CAP you will notice a plug, remove this plug using a screw-
driver this reveals the filling hole.
4. Refill by pouring toner into the fill hole through the nozzle attached to the toner
bottle.
5. Replace the plug when finished refilling, and replace the end cap making sure the
pins line up correctly.