© All rights reserved, Easy Group, LLC. Version 2.0
All trademarks are property of their respective owners. Uni-Kit
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
REQUIRED FOR A SUCCESSFUL REFILL:
Toner (Uni-Kit Formula 1A)
1 funnel cap
1 hole plug
Toner Hole Making Tool
General Refilling Procedures:
Rest the Hole Making Tool on its stand and plug into an outlet. Wait 3 full minutes
before using. Position the copper bit on the cartridge in the spot indicated by the pho-
tograph and push gently until it melts a hole in the cartridge. Remove the tool, place it
back on its stand and unplug it. If the small piece of plastic has fallen into the cartridge,
it must be removed, as this can damage your cartridge or cause print defects. If the
piece remains in the tool, wait for the tool to cool down and pry it out.
Before opening the bottle of toner, turn it upside down and tap it on a table to loosen the
toner and allow it to flow freely. Remove the cap and pull the seal off the bottle. Attach
the funnel cap making to sure it is on tightly. Tilt the funnel cap toward the filling hole
and insert it into the hole. If the toner stops flowing before the cartridge is full, simply
remove the toner, close the cap, turn the bottle upside down and tap it on a table. Once
the cartridge is full seal the hole with the plug.
Do not press down on the plug since the cartridge is resting on a table this can actually
damage the photo-optic drum. Instead hold one end of the cartridge up off the table
and twist the plug until it fully sealed. Now gently shake the cartridge side to side to
distribute the toner.
HP - 92298A / X
Canon - EPE
Canon - FX5
Apple - M2473A / G
DEC - LN0XXAA
Lexmark- 140198A / X