Page 39

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.

Xerox 6R914

Sharp AL100TD

REQUIRED FOR A SUCCESSFUL REFILL:

Toner (Uni-Kit Formula 5A)

1 funnel cap

General Refilling Procedures:

Use a screwdriver to remove the small screws holding the end cap in place. The lock-

ing tabs will unlock when you gently pry the off the end cap You will now see a large

plastic plug. Use a flathead screwdriver to pop out the large plastic plug found on the

side of the side of the cartridge.

Before opening the bottle of toner, turn it upside down and tap it on a table to loosen

the toner and allow it to flow freely. Remove the cap and pull the seal off the bottle.

Attach the funnel cap making to sure it is on tightly. Tilt the funnel cap toward the fill-

ing hole and insert it into the hole. If the toner stops flowing before the cartridge is full,

simply remove the toner, close the cap, turn the bottle upside down and tap it on a table.

Once the cartridge is full, seal the hole with the plug by twisting it until it is completely

seated. Now gently shake the cartridge side to side to distribute the toner.

DEVELOPER NOTE:

Adding developer onto your cartridge's magnetic roller is similar to pouring mustard

on a hotdog. Applying less developer is better than applying too much developer.

Pour a thin bead of developer across the length of the magnetic roller.

Rotate the roller counter-clockwise (to spread the developer across the magnetic roller

) then print a sample.

If the printer takes a while to "warm up," then try adding a little more developer. This

time, rotating the magnetic roller clockwise. Note: When finished, the magnetic roller

will be "bald" in some areas. This is normal.