© All rights reserved, Easy Group, LLC. Version 2.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
19
REQUIRED FOR A SUCCESSFUL REFILL:
Toner (Uni-Kit Formula 7A)
1 funnel cap
1 hole plug
Toner Hole Making Tool
General Refilling Procedures:
Using your thumb, lift up the black plastic tab so that it unlocks from the cartridge
body. Rotate the entire black piece toward you. This will reveal a toner filling port.
Before opening the bottle of toner, turn it upside down and tap it on a table to loosen the
toner and allow it to flow freely. Remove the cap and pull the seal off the bottle. Attach
the funnel cap making to sure it is on tightly. Tilt the funnel cap toward the filling hole
and insert it into the hole. If the toner stops flowing before the cartridge is full, simply
remove the toner, close the cap, turn the bottle upside down and tap it on a table. Once
the cartridge is full, twist the entire black plastic piece away from you until the tab
locks back in place.
Brother TN250