© All rights reserved, Easy Group, LLC. Version 1.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
Xerox Cartridges
43
8R7903, 8R7904
1. The filling holes are located under the plastic cap. The cap is held in place with
a pin at the each corner. Use a thin flathead screwdriver or knife to remove the
cap. Important: Do not to damage the sensors on the back of the cartridge.
2. Connect the needle to the syringe and fill with ink.
3. Insert the needle into the matching hole of the color to be refilled, (see diagram
above) and push into the cartridge. Note: You will feel a slight pressure because
the cartridge contains a sponge.
4. Inject about 10 ml. of ink, per color, into the cartridge until the ink begins to
bubble at the top of the sponge. Important: Do not overfill. Keep the sponge
inside the cartridge white.
5. Rinse the needle and syringe with water and dry between each color refilling or
store for future use.
6. The cover can be put back onto the cartridge by pressing it down.
Cyan
Unused
Filling hole
Yellow
Magenta
Black
Sensors
Plastic
Cover