© All rights reserved, Easy Group, LLC. Version 1.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
Lexmark Cartridges
33
1380490, 1380491, 1380492, 1380493
1. The filling hole is the same hole as the hole that connects to the printer.
2. Note: The cartridge is lined in a delicate Mylar bag and it is very important not
to insert the needle more than 3/4" or it is possible to pierce or tear the Mylar
bag. Fill the syringe with the correct color ink and carefully insert the needle
into the filling hole and slowly inject approximately 90 ml. of ink into the
cartridge.
3 Hold the cartridge upright with the filling hole at the top. Using the syringe,
remove any trapped air in the cartridge by only inserting the tip of the needle
and pulling up on the plunger until all air is removed.
4. Remove the syringe and rinse with water and dry for future use, or to use with a
different color ink.
5. Reinsert the cartridge and run a priming cycle as per printer instructions.
Note: Immediately refill any empty cartridges.
NOTE: It is not necessary to disassemble the cartridge to refill it and we strongly
recommend you do not. We have included a picture of the inside of the cartridge
to satisfy your curiosity.
Front of
Cartridge
Filling Hole
Waste
Ink Port