© All rights reserved, Easy Group, LLC. Version 1.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
Hewlett Packard Cartridges
28
C6656A, C6657A, C6658A, C8727A,
C8728A, C8766W, C8765W, C9359A,
C8767W, C9368A, C9369W, C9363W
1. Connect the needle to the syringe. Using the needle, pierce through the label
into the cartridge. Note: We have removed the label to illustrate where the
filling holes are located. You can do the same.
2. After you have pierced the label, fill the syringe with the correct color of ink.
3. Insert the needle into the cartridge of the filling hole. Slowly inject ink into the
cartridge is full. Use approximately 5 ml per chamber.
4. Use a piece of tape to seal the hole(s) made in the top label. Note: The cartridge
will leak if the holes are not sealed properly.
5. Rinse the syringe with water and dry between each color refill or store for fur
ther use.
6. Reinstall the cartridge and run 1 - 3 test pages as per printer instructions. If
necessary leave cartridge in printer for up to 24 hours to allow ink to flow to the
print head.
NOTE: This time is greatly reduced if the cartridge is refilled before it is com
pletely empty.
Black Cartridge:
C6656, C8727, HP94, HP92,
HP96, etc.
Inkjet only black ink into the holes
closest to the printheads ONLY.
Color Cartridge:
C6657, C8728, HP93, 95, 97, etc.
Photo Cartridge:
ex. C6658
M = Magenta
Y = Yellow
C = Cyan
PM = Photo Magenta
PC = Photo Cyan
BK = Black