© All rights reserved, Easy Group, LLC. Version 1.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
Canon Cartridges
BJI-201BK HC, BJI-201BK, BJI-201C, BJI-201M, BJI-201Y
1. With the cartridge upside down, using a screwdriver, push in the ball bearing that seals
the filling hole. NOTE: There are several versions of these cartridges. One version has
the filling hole under the label on the top of the cartridge. Another version does not
have a ball bearing at all. In this case it would be necessary to make a hole for the
needle to be inserted. Make this hole in the same spot where the ball bearing would be
located, as shown below. Seal hole with the plug provided.
2. Connect the needle to the syringe and fill with ink.
3. Inject about 5 ml. of ink into the filling hole until the tank is full.
4. Use the included plug to seal the filling hole, make sure that the plug is sitting flush in
the cartridge. Additional Note: If the cartridge has been empty/dry, the sponge will no
longer accept any ink which will cause the cartridge to leak.
5. Rinse the syringe with water and dry for future use, or use with a different color ink.
6. Reinsert the cartridge and run a priming cycle as per printer instructions.
Note: Immediately refill any empty cartridges.
9
Filling Hole
Outlet Hole